HP Omnibook XE3 Service Manual

2-8 Removal and Replacement HP Omnibook XE3 (Technology Codes GE and GD)
Figure 2-5. Removing the Mini-PCI PCA
Reassembly Notes
•
Reattach the cable (modem models only) or cables (modem/LAN models only) to the PCA, and
tuck them into the compartment.
•
Gently press the PCA into the connector at an angle of about 30°, until it is fully inserted. Then
press down on both sides of the PCA until the latches snap closed.
•
Make sure sticky pads on the underside of the PCA are intact. Replace if needed.

HP Omnibook XE3 Specifications

General

Brand	HP
Model	Omnibook XE3
Category	Laptop
Language	English