HP Omnibook XE3

HP Omnibook XE3 (Technology Codes GE and GD) Removal and Replacement 2-25
Removing the Hinge Saddle Set
(HP Authorized Service Providers Only)
Required Equipment
•
#0 Phillips screwdriver.
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. Remove these additional assemblies:
•
Keyboard cover (page 2-10).
•
Keyboard (page 2-12).
•
Display assembly (page 2-18).
•
Top case (page 2-22).
3. Remove the two retaining screws from the bottom case.
Figure 2-17. Removing the Hinge Saddle Retaining Screws
Screws,
M2.5x8 mm
(
2
)