Resetting Camera
If your camera does not respond when you press any buttons,
try resettingthe camera as follows:
"_ Holding the camera upside down with the front of the
camera facing you, open the Battery/Memory card door on
the bottom of the camera.
2 If you have an optional memory card installed, remove it.
(Although removing an optional memory card is not
necessary for performing the reset,it eliminates the memory
card as a possible cause of the problem.)
3 Removethe battery from the camera, and make sure the
HPAC power adapter is not connected to the camera.
4 The Resetswitch is the
sinai] hole located above
the battery s]ot, as shown.
Pressthe straightened end
of a paper clip into the
Resetswitch until the switch
is depressed, and hold it
down for approximately
five seconds, then remove
the paper clip. The camera is now reset.
5 Reinsertthe battery and the optional memory card (if you
have one) and dose the Battery/Memory card door. You
may now usethe camera again.
112 HP Photosmart R507/R607 User's Manual
To Next Page
Loading...
