Setting the Date and Ti_e
The camera hasa clock that records the date and time at which
you take each picture. This information is recorded in the
image properties, which you can see when viewing the image
in the Image _nfoscreen (page 81 ), in the Playback menu
screen (page 75), or on your computer. You can also choose to
have the date and time imprinted on the visible image (see
Dc_te& Time _mprinf on page 67).
Thefirst time you turn the camera on, a
Da_e& Time screen appears after you
choose the language, prompting you
to set the date and time.
"] Adjust the value of the highlighted
selection using theAvbuttons, o"'- "
2 Pressthe _ _ buttons to move to the other selections.
3 Repeat steps 1 and 2 until the correct date/time format,
date, and time are set.
4 Pressthe Menu/OK button when you have entered the
proper values for the date and time. A confirmation screen
appears, asking if the correct date and time have been set.
S If the date and time are correct, press the Menu/OK button
to select Yes.
If the date and time are incorrect, pressthe v button to
highlight No, and then press the Menu/OK button. The
D_e & Time screen appears again. Repeat steps 1 through
5 to setthe correct date and time.
NOTE If you need to change the date and time settings later,
you can do this with the Da_e& Time setting in the Setup
menu. See Chapter 6: Using the Setup Menu on
page 103.
18 HP Photosmart R507/R607 User's Manual
To Next Page
Loading...
