nstaBBinga Memory Card (Op ionaB}
NOTE If you do not have a memory card, skip this section and
go an to the next section, _nsfaIting_h÷ BGfferyon
page 14.
Your camera contains internal memory that allows you to store
images and video clips. However, you can use a memory card
(purchased separately) instead to store images and video clips.
For more information about supported memory cards, see
Storage on page 167.
When you install a memory card in the camera, all new
images and video clips are stored on the card. Thecamera's
internal memory is only used when there is no memory card in
the camera.
Hold the camera with the bottom facing
up, as shown, and slide the Battery/
Memory card door latch to open the
Battery/Memory card door.
2 With the back of the camera
facing up, insert the memory card
in the smaller slot with the notched
side of the card going in first, as
shown. Make sure the memory
card snaps into place.
3 Leavethe Battery/Memory card
door open and go on to the next section, Installing the
BaHeryon page 14.
To remove the memory card from the camera, firstturn the
camera off. Then open the Battery/Memory card door, press
down on the top edge of the memory card, and it will spring
outward from the slot.
Chapter 1: Getting Started 13
To Next Page
Loading...
