HP ProCurve 2810 Series

10-16
Traffic/Security Filters
Using Source-Port Filters
Using the IDX value in the show filter command, we can see how traffic is
filtered on a specific port (Value).The two outputs below show a non-
accounting and an accounting switch port.
Figure 10-10. Show Filter on a Specific Port
ProCurve(config)# show filter 4
Traffic/Security Filters
Filter Type : Source Port
Source Port : 5
Dest Port Type | Action
--------- --------- + -------
1 100/1000T | Forward
2 100/1000T | Forward
3 100/1000T | Forward
4 100/1000T | Forward
5 100/1000T | Forward
6 100/1000T | Forward
7 100/1000T | Forward
8 100/1000T | Forward
9 100/1000T | Forward
10 100/1000T | Forward
11 100/1000T | Forward
12 100/1000T | Forward
ProCurve(config)# show filter 24
Traffic/Security Filters
Filter Type : Source Port
Source Port : 10
Dest Port Type | Action
--------- --------- + -------
1 100/1000T | Drop
2 100/1000T | Drop
3 100/1000T | Drop
4 100/1000T | Drop
5 100/1000T | Drop
6 100/1000T | Drop
7 100/1000T | Forward
8 100/1000T | Drop
9 100/1000T | Drop
10 100/1000T | Forward
11 100/1000T | Forward
12 100/1000T | Drop