HP ProCurve 5400zl Installation And Getting Started Guide

2-8
Installing the 5400zl Switches
Installation Procedures
Installing the 5400zl
Switches
■ Once the module is fully inserted, screw in the two retaining screws to
secure the module in place. The screws should be tightened until they are
secure, but not overtightened.
■ If you do not use one or more of the slots, ensure the slot cover plate is
still attached over the slot for safe operation and proper switch cooling.
For safety, you should not have more than one module slot uncovered at
a time.
■ Although these procedures show the 6-slot chassis, the procedures are
the same for the 12-slot chassis.
Figure 2-1. Module Being Installed in a Chassis
Insert module into the guides and
slide it in until it is fully inserted.
Open extractor handles

HP ProCurve 5400zl Specifications

General

Brand	HP
Model	ProCurve 5400zl
Category	Switch
Language	English