HP ProCurve Series 3400cl User Manual

142
Enhancements
Release M.10.66 Enhancements
Figure 30. Example of the Logging Command with a Priority Description
Note
A notification is sent to the SNMP agent if there are any changes to the syslog parameters either
through the CLI or with SNMP.
Command Differences for the ProCurve Series 2600/2800/3400cl/6400cl
Switches
CLI Commands. The ProCurve series 2600/2800/3400cl/6400cl switches do not have the following
CLI logging commands:
• logging severity
• logging system-module
SNMP Commands. The ProCurve series 2600/2800/3400cl/6400cl switches do not support the
following SNMP objects:
• hpicfSyslogPrioritySeverity
• hpicfSyslogSystemModule
Operating Notes
■ Duplicate IP addresses are not stored in the list of syslog servers.
■ If the default severity value is in effect, all messages that have severities greater than the
default value are passed to syslog. For example, if the default severity is “debug”, all messages
that have severities greater than debug are passed to syslog.
■ There is a limit of six syslog servers. All syslog servers are sent the same messages using the
same filter parameters.
■ An error is generated for an attempt to add more than six syslog servers.
ProCurve(config)# logging priority-descr severe-pri

HP ProCurve Series 3400cl Specifications

General

Brand	HP
Model	ProCurve Series 3400cl
Category	Switch
Language	English