168
Software Fixes in Release M.08.51 - M.10.72
Release M.10.28
Release M.10.28
Problems Resolved in Release M.10.28 (Not a general release)
■ CLI/LLDP (PR_1000377191) — Output from the CLI command, "show lldp info remote-
device <port>" shows a blank field for the chassis ID.
■ CLI (PR_1000390970) — The command "tftp-enable" is removed from the CLI since that
functionality is served by "tftp server|client".
■ CLI/Counters (PR_1000379222) — Jumbo sized frames received on 10GbE ports decre-
ment the "Total Rx Errors" counters. The 32 bit counter rolls from 0 backwards to 4,294,967,295
and continues to decrement with each received Jumbo frame.
■ Trunking (PR_1000238829) — Trunks numbered trk10 and greater cause the output from
the CLI command "show span" output to be misaligned.
Release M.10.29
Problems Resolved in Release M.10.29 (Never released)
■ CLI/Config (PR_1000375830) — When using the "no VLAN" command, the user is asked
if they want to remove the VLAN. Answering "no" will result in the VLAN being removed
anyway.
■ CLI/config (PR_1000391119) — Copying a configuration file to a switch with a BPDU
protection timeout value set may produce an error similar to:
CCCCCline: 10007. 1200: Error setting configuration
■ CLI (PR_1000390385) — The CLI help text for "span bpdu-protection-timeout" is incorrect;
it erroneously displays the help text for "span hello-time."
■ Enhancement (PR_1000376626) — Enhance CLI "qos dscp-map he" help and "show dscp-
map" text to warn the user that inbound classification based on DSCP codepoints only occurs
if "qos type-of-service diff-services" is also configured.
■ Lockup (PR_1000394749) — Switch may lockup when a certain J4858A transceiver type
is inserted.
■ SNMP (PR_1000392847) — RMON alarms that monitor port-specific OIDs are lost if the
switch is rebooted.
■ Traceroute (PR_1000379199) — The reported "traceroute" time is inaccurate; it is one
decimal place off.
To Next Page
Loading...
