170
Software Fixes in Release M.08.51 - M.10.72
Release M.10.32
■ RIP (PR_1000393366) — The switch does not process RIP (v2) responses containing
subnets with a classful subnet mask, when the receiving RIP switch has a connected VLSM
network defined that would fall within that classful range.
■ Enhancement (PR_1000372989) — This enhancement enables the user to set the oper-
ator/manager username/password via SNMP.
Release M.10.32
Problems Resolved in Release M.10.32
■ CLI (PR_1000373443) — The CLI "update" command help text and confirmation message
is misleading and confusing.
■ Enhancement (PR_1000376626) — Enhanced the CLI "qos dscp-map he" help and "show
dscp-map" text to warn user that inbound classification based on DSCP codepoints only
occurs if "qos type-of-service diff-services" is also configured.
■ Security (PR_1000401384) — The intrusion flag never comes up for secure ports.
■ RX counters (PR_1000401065) — ACL deny matches on a port cause the Rx Drop counter
to increment on software versions M.10.20 or higher.
■ RX counters (PR_1000401395) — Drops Rx (ifInDiscards) incorrectly increments if a
port is blocked by LACP, or if the port receives tagged traffic from a VID for which that port
is not a member.
■ Crash (PR_1000392863) — The switch may crash when "setmib tcpConnState" is
used, with a message similar to:
NMI event SW:IP=0x0079f4a0 MSR:0x00029210 LR:0x006dca60
Task='eTelnetd' Task ID=0x8a7cbb0 cr: 0x20000042 sp:0x08a7c872
■ 802.1p (PR_1000392900) — The switch adds 802.1p Priority 4 to frames forwarded on
VLAN tagged ports destined to the IP multicast group 224.0.0.1 (all hosts).
■ RSTP (PR_1000401394) — When a dynamic LACP trunk transitions to either link-up, or
link-down, this action occasionally triggers RSTP instability within the switch. This can
result in loops and broadcast storms.
■ Enhancement (PR_1000401306) — Reload "IN/AT" special enhancement.
Release M.10.33
Problems Resolved in Release M.10.33
To Next Page
Loading...
Need help?
General