149
Software Fixes in Release M.08.51 - M.10.72
Release M.08.68
Release M.08.68
Problems Resolved in Release M.08.68 (Not a general release)
■ Switching (PR_1000232312) — In cases where traffic is being L2 switched or L3 routed
from one port at Gigabit speeds to a group of ports (i.e. to a VLAN) where one of the outbound
ports is running at a slower speed, traffic may have been dropped even to egress ports running
at Gigabit speeds. This PR addresses the dropped packets for the Gig-to-Gig port traffic. Gig-
to-100Mbps transfers may still experience packet drops due to congestion (as is normal in
any oversubscribed scenario).
Release M.08.69
Problems Resolved in Release M.08.69
■ 802.1s STP (PR_1000229407) - Edge port configuration is lost after the configuration file
is transferred using TFTP.
■ 802.1X (PR_1000208530) - Switch may crash with 802.1X configured, with a message
similar to:
Crash: aaa8021x_init dereferencing a null pointer, writing to low
memory
■ CLI (PR1000202435) — “show config” does not show IGMP fast-leave configuration.
■ Config (PR_94943) — Setup Screen allows Proxy-ARP configuration when IP routing is
disabled
■ Config (PR1000216051) — Copying a previously saved startup-configuration with “stack
join (mac address)” to a member switch of the IP stack will break the membership of that
stack.
■ Crash (PR_1000229656) - switch crashes when RADIUS is unavailable.
■ Crash (PR_1000233993) - Switch may crash with a message similar to:
Software exception at exception.c:373 -- in 'mSnmpCtrl', task ID =
0x5b85fd0 -> Memory system error.
■ Crash (PR_1000239085) - The switch may crash with a message similar to:
Software exception at esi_stacking.c:2578 -- in 'tHttpd'.
■ DHCP (PR1000207419) — DHCP Relay agent is disabled by default.
■ IP Helper/DHCP Relay (PR_1000197046) - IP helper may not handle "DHCP Inform" relay
properly.
■ Menu (PR_1000221018) - Setup Menu allows Proxy-ARP configuration when IP routing
is disabled.
To Next Page
Loading...
Need help?
General