177
Software Fixes in Release M.08.51 - M.10.72
Release M.10.50 through M.10.64
Routed traffic is off by a factor of 1000
Switched traffic is not sampled at all
■ Security (PR_1000388616) — Possible cross-site scripting vulnerability in Web Manage-
ment Interface.
■ Config (PR_1000763386) — An SNMPv3 user is not reflected in startup config as it should
be. This is an additional fix for PR_1000750637.
■ CLI (PR_1000713515) — When the CLI command erase startup config is issued, the switch
asks whether you want to save the config.
■ Transceivers (PR_1000467314) — Revision C mini-GBICs are being incorrectly displayed
as revision B.
■ Crash (PR_1000471594) — Use of the CLI command show config <file> may cause the
switch to crash with a message similar to the following.
TLB Miss: Virtual Addr=0x00000004 IP=0x80150828 Task='mSess1' Task
ID=0x85e48550 fp:0x85e47978 sp:0x85e478e0 ra:0x801507cc
sr:0x1000fc01
■ Crash (PR_1000464612) — Booting from the secondary image, or some types of configu-
ration file manipulation (for example, use of the CLI command erase start) may cause the
switch to crash with a message similar to the following.
Software exception at ConfigTree.cc:508 -- in 'mChassCtrl'.
■ Tagged/Untagged VLANs (PR_1000759034) — Trunks may transmit tagged frames from
untagged VLANs.
■ QoS (PR_1000454194) — When using the Web Management interface to configure VLAN
based QoS, the VLANs do not show up in the configuration window as selectable when
applying a DSCP or QoS value.
■ Web Auth (PR_1000380278) — After running for a period, the switch will get into a state
in which it must be rebooted in order for the Web authentication page to load.
Release M.10.50 through M.10.64
Problems Resolved in Release M.10.50 - M.10.64 (Never Built)
Release M.10.65
Problems Resolved in Release M.10.65 (Not a Public Release)
To Next Page
Loading...
Need help?
General