EasyManua.ls Logo

HP ProCurve Series 3400cl

HP ProCurve Series 3400cl
197 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
182
Software Fixes in Release M.08.51 - M.10.72
Release M.10.70
Dynamic ARP Protection (PR_0000009942) — When a switch using Dynamic ARP
Protection is rebooted, it blocks all ARP traffic on untrusted ports, including traffic consid-
ered valid according to the binding database. On trusted ports, traffic flows normally.
Workarounds: either disable / re-enable ARP protect, or configure ports to be trusted, and
then untrusted again.
802.1X Authentication (PR_0000011718) — When an 802.1X enabled port belongs to a
VLAN that is jumbo enabled, the Access-Request will specify a value of Framed-MTU of 9182
bytes. This allows the RADIUS server to reply with a large fragment which the switch does
not process, causing the authentication to fail.
CLI (PR_0000009868) — Execution of a show command in one telnet or console session
prevents successful execution of a show command in a concurrent management (CLI)
session.
Crash (PR_0000003523) — Disabling a port with Dynamic IP Lockdown (DIPLD) and
802.1X enabled may cause the switch to reboot unexpectedly with a message similar to the
following:
Software exception at idmCommonAcl.c:1547 -- in 'midmCtrl', task ID
= 0x85cc1eb0
802.1X (PR_0000010850) — If an unauth-vid is configured, and the client limit is reached
on a switch port, a properly credentialed re-authentication following an improperly creden-
tialed authentication attempt (for example, incorrect password) will leave the 802.1x client
in the unauthorized VLAN instead of applying the appropriate authorized VLAN.
SNMP Traps (PR_0000007448/1000469020) — The switch no longer sends warm/cold
start SNMP traps on reload/boot.
802.1X (PR_0000009344) — The switch sends an EAP-notification out to the client as a
result of the Radius server sending a Reply-Message in the Access-Accept packet after EAP-
Success. This fix follows the suggestion in RFC 3579, section 2.6.5 and silently discards
attributes sent out after the authentication is complete.
Crash (PR_0000009411) A switch with 802.1X and RADIUS accounting configured may
experience an unexpected reboot with a message similar to the following.
Software exception at aaa8021x_proto.c:255 -- in 'm8021xCtrl'
CLI Help (PR_0000010484) — The CLI tab completion for the command parameter
[ethernet] PORT-LIST
should list the all option, but it does not.
Crash (PR_0000012124) — Switches configured for meshing may reboot unexpectedly
with a message similar to the following.
Software exception at ldbal_util.c:2525 -- in 'mLdBalCtrl'
MAC Authentication (PR_0000011949) — MAC authentication may fail to take place
unless the switch port status is toggled.

Table of Contents

Related product manuals