Setup 29
WARNING:
When installing a server in a telco rack, be sure that the rack frame is adequately
secured at the top and bottom to the building structure.
Identifying the contents of the server shipping carton
Unpack the server shipping carton and locate the materials and documentation necessary for installing the
server. All the rack mounting hardware necessary for installing the server into the rack is included with the
rack or the server.
The contents of the server shipping carton include:
• Server
• Power cord
• Rack rail hook-and-loop strap
• Printed setup documentation
• Rack mounting hardware kit and documentation (optional)
You need the following items for some procedures:
• T-25 Torx screwdriver (to loosen the shipping screws located inside the server quick-release latch rack
ears)
• T-10/T-15 Torx screwdriver
• Flathead screwdriver (to remove the knockout on the dedicated iLO connector opening)
• Hardware options
• Operating system or application software
Installing hardware options
Install any hardware options before initializing the server. For options installation information, see the option
documentation. For server-specific information, see "Hardware options installation (on page 36)."
Installing the server into the rack
To install the server into a rack with square, round, or threaded holes, refer to the instructions that ship with
the rack hardware kit.
If you are installing the server into a telco rack, order the appropriate option kit at the RackSolutions.com
website (http://www.racksolutions.com/hp). Follow the server-specific instructions on the website to install
the rack brackets.
To Next Page
Loading...
