EasyManua.ls Logo

HP ProLiant DL160 Gen9 - Installing a DIMM; Online Spare Population Guidelines

HP ProLiant DL160 Gen9
135 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Hardware options installation 62
Online spare population guidelines
For Online Spare memory mode configurations, observe the following guidelines:
Observe the general DIMM slot population guidelines (on page 61).
Each channel must have a valid online spare configuration.
Each channel can have a different valid online spare configuration.
Each populated channel must have a spare rank. A single dual-rank DIMM is not a valid configuration.
Mirrored Memory population guidelines
For Mirrored Memory mode configurations, observe the following guidelines:
Observe the general DIMM slot population guidelines (on page 61).
Always install DIMMs in channels 1 and 2 for each installed processor.
Do not install DIMMs in channel 3 for any processor.
DIMMs installed on channel 1 and channel 2 of an installed processor must be identical.
In multi-processor configurations, each processor must have a valid Mirrored Memory configuration.
In multi-processor configurations, each processor may have a different valid Mirrored Memory
configuration.
Lockstep Memory population guidelines
For Lockstep memory mode configurations, observe the following guidelines:
Observe the general DIMM slot population guidelines (on page 61).
DIMM configuration on all channels of a processor must be identical.
In multi-processor configurations, each processor must have a valid Lockstep Memory configuration.
In multi-processor configurations, each processor may have a different valid Lockstep Memory
configuration.
When high performance heatsinks are installed on the server, do not install DIMMs in channel 2 or
channel 4.
Installing a DIMM
1. Power down the server (on page 17).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 17).
o Remove the server from the rack (on page 19).
4. Remove the access panel (on page 20).
5. Remove the expansion board.
6. Open the DIMM slot latches.

Table of Contents

Other manuals for HP ProLiant DL160 Gen9

Related product manuals