Hardware options installation 39
7.
Install the drive.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
8. If removed, install the security bezel ("Security bezel option" on page 36).
9. Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server (on page 17).
To configure arrays, see the HP Smart Storage Administrator User Guide on the HP website
(http://www.hp.com/go/smartstorage/docs).
Installing a hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To install the component:
1. If installed, remove the security bezel ("Remove the security bezel (optional)" on page 20).
2. Remove the drive blank.
To Next Page
Loading...
