Hardware options installation 71
o
Extend the server from the rack (on page 17).
a. Remove the server from the rack (on page 19).
4. Remove the access panel (on page 20).
5. If necessary, disconnect any internal cables connected to the system board.
6. Remove the PCI riser cage (on page 21).
Retain the cage for future use.
7. Remove the blank from the FLexibleLOM slot of the riser cage.
Retain the blank for future use.
8. Install the component:
a. Firmly seat the FlexibleLOM into the slot.
To Next Page
Loading...
