2
Removal and Replacement Procedures
This chapter provides subassembly and module-level removal and replacement procedures
for HP ProLiant DL320 Generation 2 servers. After completing all necessary removal and
replacement procedures, run the diagnostics program to verify that all components operate
properly.
The following diagnostic programs and tools may be used:
•
•
•
•
•
•
•
•
•
•
•
•
Phillips screwdriver
Shipping/ejector key
SmartStart CD
— ROM-Based Setup Utility (RBSU)
— Array Diagnostics Utility (ADU)
— Diagnostics software
Wrist strap
Electrostatic Discharge Information
An electrostatic discharge (ESD) can damage static-sensitive devices or microcircuitry.
Proper packaging and grounding techniques are required to prevent damage. To prevent
damage due to ESD, observe the following precautions:
Transport products in static-safe containers such as conductive tubes, bags, or boxes.
Keep electrostatic-sensitive parts in their containers until they arrive at static-free
stations.
Cover workstations with approved static-dissipating material. Use a wrist strap connected
to the work surface as well as properly grounded tools and equipment.
Keep the work area free of nonconductive materials such as ordinary plastic assembly
aids and foam packing.
Ensure proper grounding before touching a static-sensitive component or assembly.
Avoid touching pins, leads, or circuitry.
Always place drives with the Printed Circuit Board (PCB) assembly-side down.
Use conductive field service tools.
HP ProLiant DL320 Generation 2 Server Maintenance and Service Guide 2-1
To Next Page
Loading...
Need help?
General
