HP ProLiant ML350 Gen9 - 8-LFF Drive Backplane

Removal and replacement procedures 65
o
Two SAS Expanders
15. Close the PCI slot retainer cover.
16. Install the fan cage.
17. Install the air baffle.
18. Install the access panel.
19. Do one of the following:
o If the server is in a tower configuration, return the server to an upright position.
o If the server is in a rack configuration, slide the server into the rack.
20. Connect each power cord to the server.
21. Connect each power cord to the power source.
22. Power up the server ("Powering up the server" on page 28).
23. Do one of the following:
o For tower models, install the tower bezel.
o For rack models, install the security bezel.
8-LFF drive backplane
To remove the component:
1. Back up all server data.
2. Do one of the following:
o For tower models, open and remove the tower bezel (on page 28).
o For rack models, if installed, remove the security bezel ("Remove the security bezel (optional)"
on page 28).
3. Power down the server (on page 29).
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.