HP ProLiant ML350 Gen9 - Front I;O Assembly

Removal and replacement procedures 37
a.
Disconnect the SATA cables from the M.2 SSD enablement board.
b. Open the slot cover retainer and remove the failed M.2 SSD enablement board.
To replace the component, reverse the removal procedure.
Front I/O assembly
To remove the component:
1. Do one of the following:
o For tower models, open and remove the tower bezel ("Remove the tower bezel" on page 28).
o For rack models, if installed, remove the security bezel ("Remove the security bezel (optional)"
on page 28).
2. Power down the server (on page 29).
3. Remove all power:
a. Disconnect each power cord from the power source.