Removal and Replacement Procedures
10. Loosen the thumbscrew that secures the retaining bracket to the diskette chassis (1).
11. Pull the diskette retaining bracket forward to disengage the tabs and lift the bracket from
the chassis (2).
12. Pull the diskette drive backward about 1 cm (0.4 in) and lift up to clear the base (3).
NOTE: The drive cage is removed for clarity in Figure 2-40.
Figure 2-40: Removing the diskette drive
13. Remove the diskette drive from the chassis.
To replace the diskette drive:
1. Place the diskette drive back into the chassis, flush with the front of the server.
2. Slide the diskette retaining bracket into place.
3. Secure the thumbscrew.
4. Reconnect the diskette drive cable to the diskette drive and the system board.
5. Reconnect the power cable to the diskette drive.
HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide 2-43
To Next Page
Loading...
