Removal and Replacement Procedures
To replace the processor assembly:
1. Open the processor retaining bracket
2. Install the processor/heatsink assembly into the available processor socket:
a. Determine the correct processor orientation by observing the three guide pins on the
processor retaining bracket and the three corresponding guide holes on the
processor/heatsink assembly.
Figure 2-43: Aligning the processor for installation
b. Be sure the processor locking lever is open.
c. Insert the processor/heatsink assembly into the processor socket (1).
d. Close the processor locking lever (2).
IMPORTANT: If the processor locking lever is not secured, the processor retaining bracket will not
close properly.
2-46 HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide
To Next Page
Loading...
