Table 20 Smart Array controller POST error codes (continued)
Corrective actionLevelDescriptionError
code
Contact your HP support representative
for assistance.
CriticalSlot z Drive Array Controller Failure (might be
followed by an exclamation point, and one or
more of the following:)
1783
• [Board ID not programmed (replace ROMs or
replace controller)]
• [I2C read error]
• [Image checksum error]
• [Inconsistent volume count]
• [Inconsistent volume count (B)]
• [Unexpected hardware revision]
• [Incorrect EEPROM type]
• [Init failure (cmd=##h, err=##h)]
• [Command failure (cmd=##h, err=##h)]
• [Self-test failure (ErrCode=####h)]
• [I2C NVRAM reconfiguration failure]
• [PCI bridge missing]
• [PCI bridge disabled; check System ROM
version]
• [Board ID not programmed]
Replace the indicated disk.InformationalSlot z Drive Array Drive Failure The following disk
drive(s) should be replaced:
1784
Port 1I: Box 1: Bay 3
Follow the instructions in the error
message to correct the error condition.
Informational or
Critical
Slot z Drive Array not Configured (followed by
one of the following:)
1785
• No drives detected.
• Array Accelerator Memory Size Increased - Run
System Configuration Utility.
• SAS Cable(s) Attached to Wrong SAS Port
Connector(s). Turn system power OFF and swap
SAS port connectors to prevent data loss.
• Drive positions cannot be changed during
Capacity Expansion.
• Drive positions appear to have changed. Run
Drive Array Advanced Diagnostics if previous
positions are unknown. Then turn system power
OFF and move drives to their original positions.
• Configuration information indicates drive
positions beyond the capability of this
controller. This may be due to drive movement
from a controller that supports more drives than
the current controller. To avoid data loss turn
system power OFF and reattach drives to the
original controller.
• Configuration information indicates drives were
configured on a controller with a newer
firmware version. To avoid data loss, reattach
drives to original controller or upgrade
controller firmware.
POST error codes 113
To Next Page
Loading...
Need help?
General