Read caching percentage can be 0, 25, 50, 75, or 100.
To enable or disable auto-fail missing disks at boot
saconfig /dev/cissX -F on|off
To identify (light LED) SAS/SATA physical drives
saconfig /dev/cissX -I -p <physical_drive_id>
[-p <physical_drive_id> ... ]
To identify SAS/SATA physical drives constituting a logical drive
saconfig /dev/cissX -I -l <Logical drive #>
To extend the capacity of the specified logical drive up to larger
capacity. The capacity is in GB.
saconfig /dev/cissX -E <Logical drive #> -c <capacity (GB)>
To expand the specified logical drive and others in an array by
physical drive(s)
saconfig /dev/cissX -E <Logical drive #> -p <physical_drive_id>
[-p <physical_drive_id> ... ]
To perform RAID level [with Stripe size (KB)] migration on the specified
logical drive. The stripe size is in KB.
saconfig /dev/cissX -M <Logical drive #> -R <RAID level>
[-S <Stripe size (KB)>]
To perform Stripe size migration on the specified logical drive.
The stripe size is in KB.
saconfig /dev/cissX -M <Logical drive #> -S <Stripe size (KB)>
To view the saconfig manpage for more information, see saconfig(I).
Before running saconfig to configure the storage devices connected to a Smart Array Controller,
you must know the device file name for the Smart Array Controller. See “Determining the Smart
Array controller device file” (page 34).
Displaying the Smart Array controller configuration
To display the physical disks connected to a Smart Array Controller and configured logical drives
and spare drives, use the saconfig /dev/cissX command. Replace X with the device file
number for the Smart Array Controller.
The Connector/Enclosure/Bay, WWID, size, and status of each physical disk attached to the Smart
Array Controller is included in the saconfig /dev/cissX output. If logical drives are configured
on the Smart Array Controller, a detailed description of those drives appears:
# saconfig /dev/ciss5
******************** SmartArray RAID Controller /dev/ciss5 ********************
Auto-Fail Missing Disks at Boot = enabled
Cache Configuration Status = cache enabled
Cache Ratio = 50% Read / 50% Write
---------- PHYSICAL DRIVES ----------
Location Ct Enc Bay WWID Size Status
Internal 1I 1 12 0x500000e01117c732 36.4 GB OK
Internal 1I 1 11 0x500000e01115c352 36.4 GB OK
Internal 1I 1 10 0x5000c5000032b839 36.4 GB OK
Internal 1I 1 9 0x5000c5000030b0c5 36.4 GB OK
Internal 2I 1 16 0x500000e011213482 36.4 GB OK
Internal 2I 1 15 0x5000c500002084c9 73.4 GB OK
Internal 2I 1 14 0x5000c5000030b9c9 36.4 GB UNASSIGNED
The saconfig configuration CLI 45
To Next Page
Loading...
Need help?
General