---- DRIVER INFORMATION ------------------------------------------------------
Driver State........................ READY
---- CONTROLLER INFORMATION --------------------------------------------------
Controller Product Number........... P400
Controller Product Name............. HP PCIe SmartArray P400
Hardware Path....................... 0/6/0/0/0/0/1/0/0/0
Device File......................... /dev/ciss5
---- FIRMWARE DOWNLOAD -------------------------------------------------------
** You are downloading the firmware image “INCPTR.PAK”
** to the controller “/dev/ciss5”.
Retrieving firmware image file from disk................... [Done]
Validating the file’s signature and size................... [Done]
Retrieving the firmware revision string from ROM........... [Done]
Retrieving the firmware revision string from the file...... [Done]
Current Revision (in ROM)....... 2.06
New Revision (in file).......... 2.08
WARNING: The firmware download process may take several minutes to
complete. All I/O to this controller will be temporarily
halted during this time.
Are you sure you want to continue (y/n)? y
Preparing for download..................................... [Done]
Sending the new firmware to the controller................. [Done]
Activating the new firmware................................ [Done]
Resetting the controller................................... [Done]
Retrieving the firmware revision string from ROM........... [Done]
Current Revision (in ROM)....... 2.08
FIRMWARE DOWNLOAD WAS SUCCESSFUL!
******************************************************************************
**** End of SAUTIL Output ****
******************************************************************************
Updating physical disk firmware online
The sautil physical disk firmware update command syntax is:
#sautil <device_file> download_dev_fw <fw_image> <physical drive id>
Where:
<device_file> The controller device file. Determine the Smart Array Controller
device file by entering the ioscan -kfn command as illustrated
in “Determining the Smart Array controller device file” (page 34).
<fw_image> The file path for the firmware version you want to install on the
physical disk. For access to the physical disk firmware image update
file, contact your HP representative.
<physical drive id> Either the Connector:Enclosure:Bay or WWID of the physical disk
where you want to change the firmware. You can determine the
80 Troubleshooting
To Next Page
Loading...
