NOTE: You cannot use ORCA to configure a logical drive using RAID 0; you must use RAID
1+0 or higher. To configure a RAID 0 logical drive online, use the saconfig command. For
more information, see “Configuring a logical drive” (page 46).
NOTE: You cannot use ORCA to configure a single spare drive to be shared among several
arrays. To configure shared spare drives, use the saconfig command. See “Adding a spare
disk drive” (page 50).
3. To accept the settings, press Enter.
4. To confirm the settings and save the configuration, press F8. After several seconds, the
Configuration Saved screen appears.
5. To continue, press Enter.
6. Create another logical drive by repeating steps 1-5 if necessary.
For more information on using ORCA, see “Using ORCA” (page 53).
Configuring a Smart Array controller as a boot device 39
To Next Page
Loading...
Need help?
General