• Set the stripe size on a RAID logical drive
• Set up online spare disk drives
• Delete logical drives
• Clear the current configuration
• Specify the percentage of the cache used for read caching
• Auto-fail missing disks at boot time
• Create multiple logical drives in an array
• Perform RAID level migration
• Perform stripe size migration
• Extend the capacity of a logical drive
• Expand the capacity of an array
• Change the expand priority
• Change the rebuild priority
To run the saconfig command, you must log in as a superuser .
To display the saconfig help screen with command options and syntax, enter saconfig without
any options. Example 1 and Example 2 (page 44) show the help screens.
The saconfig configuration CLI 41
To Next Page