---- DRIVER INFORMATION ------------------------------------------------------
Driver State........................ READY
---- CONTROLLER INFORMATION --------------------------------------------------
Controller Product Number........... P800
Controller Product Name............. HP PCIe SmartArray P800
Hardware Path....................... 0/6/0/0/0/0/1/0/0/0
Device File......................... /dev/ciss3
---- FIRMWARE DOWNLOAD -------------------------------------------------------
** You are downloading the firmware image "vw_199cg.s3r"
** to the enclosure "2E:1:0" (channel:ID)
** connected to the controller "/dev/ciss3".
Verifying that the specified target enclosure is valid..... [Done]
Retrieving firmware image file from disk................... [Done]
Validating the file's signature and size................... [Done]
Retrieving the firmware revision string from ROM........... [Done]
Current Revision (in ROM)....... 1.50
WARNING: The firmware download process may take 10+ minutes to
complete. All I/O to this controller will be temporarily
halted during this time.
Are you sure you want to continue (y/n)? y
Preparing for download..................................... [Done]
Sending the new firmware to the enclosure.................. [Done]
Flashing the enclosure with the new firmware............... [Done]
Resetting the controller................................... [Done]
Retrieving the firmware revision string from ROM........... [Done]
Current Revision (in ROM)....... 1.99
FIRMWARE DOWNLOAD WAS SUCCESSFUL!
******************************************************************************
**** End of SAUTIL Output ****
******************************************************************************
In this example, the firmware of the enclosure (SES device) at 2E:1:0 is updated from version 1.50
to 1.99.
Repeat this procedure for each enclosure where you want to update the firmware.
Checking and updating SAS storage enclosure firmware online 99
To Next Page
Loading...
Need help?
General