HP StorageWorks 8/20q Fibre Channel Switch Installation and Reference Guide 47
The following example configures SNMP trap 1:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> set setup snmp trap 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
Trap1Enabled False
Trap1Address 10.0.0.254
Trap1Port 162
Trap1Severity warning
Trap1Version 2
Trap1Community public
New Value (press ENTER to not specify value, 'q' to quit):
Trap1Enabled (True / False) :True
Trap1Address (hostname, IPv4, or IPv6 Address) :10.20.30.40
Trap1Port (decimal value, 1-65535) :
Trap1Severity (select a severity level)
1=unknown 6=warning
2=emergency 7=notify
3=alert 8=info
4=critical 9=debug
5=error 10=mark :4
Trap1Version (1 / 2) :1
Trap1Community (string, max=32 chars) :OSEMcommunity
Do you want to save and activate this snmp setup? (y/n): [n]
For more information about CLI commands, see the HP StorageWorks 8/20q Fibre Channel Switch
Command Line Interface Guide.
4. Configure the switches in OSEM by adding each 8/20q Fibre Channel Switch as a Managed System
configured with System Type set to FC Switch and the IP address for the switch. For detailed instructions,
see the OSEM documentation available at the web sites listed in ”Installation instructions and
documentation for SIM, RSP, and OSEM” (page 45).
To Next Page
Loading...
Need help?
General