Figure 108 Installing the new library controller
5. Replace the Ethernet cable, if applicable. Power on the tape library.
6. Confirm that the library recognized the new library controller by checking the System Status
on the front panel, as shown in Figure 109 (page 197).
Figure 109 MSL4048, MSL8048, and MSL8096 system status
7. Restore the previous settings by manually entering them in the OCP or RMI.
8. If necessary, upgrade the library and drive firmware using the RMI or a USB flash drive.
9. Run Library & Tape Tools (L&TT) diagnostic software to verify that the library and drives
have the latest firmware. L&TT can be downloaded without charge from http://www.hpe.com/
support/TapeTools. If necessary, upgrade the library firmware through L&TT, the RMI, or a
USB flash drive.
Removing and replacing the base chassis
In this process you will:
• Record configuration settings.
• Remove the tape cartridge from the tape drive.
• Remove the cables, drives, and magazines from the library.
Removing and replacing the base chassis 197
To Next Page
Loading...
