• WWide Node Name (FC drive only) — world wide unique number for the drive. The library
assigns WWNames to the drive bays. When a tape drive is replaced, the WWName is
re-assigned to the replacement drive.
• Port information for each configured port (FC drive only)
WWide Port Name — world wide unique identifier for the port. The WW Node and Port
Name will be slightly different.
◦
◦ Port Type — the current setting of the drive port. Direct connected devices are typically
Loop. Devices connected to a switch are typically Fabric.
◦ Speed
Viewing network information
The Identity > Network page displays information about the network configuration.
Figure 35 Identity > Network page
You can see, but not modify:
• MAC Address — a unique identifier for the library controller network interface
• Full Qualified Domain Name — the fully qualified domain name for the device
• Clock Synchronization Configuration (SNTP) — When Enabled, the device will obtain the
current time and date from the configured SNTP server.
When IPv4 Addressing is Enabled, you can see, but not modify:
• IPv4 DNS Server 1 and IPv4 DNS Server 2 — addresses of the configured DNS servers
used when DHCP Addressing is not Enabled.
• DHCPv4 Addressing — When Enabled, the device will request an IP address from a DHCP
server each time the device is booted.
Using the RMI 59
To Next Page
Loading...
