• IPv4 Address — the library network address
• Subnet Mask — The network mask of the library controller used when DHCP Addressing is
not Enabled.
• Default Gateway — the gateway used when DHCP Addressing is not Enabled.
When IPv6 Addressing is Enabled, you can see, but not modify:
• Stateless Addressing — when Enabled, the device will generate an address for itself based
on the routing information obtained from a router advertisement and the MAC address. The
device can manage up to five global addresses at the same time, which can be assigned
from different routers.
• DHCPv6 Addressing — when Enabled, the library will request an IP address from a DHCP
server each time the device is booted.
• Static Addressing — when Enabled, the device will use a statically-configured address.
• Static Assigned Address — the IPv6 address when Static Addressing Enabled is On.
Status
Viewing dynamic device information
The Status > Library page displays dynamic information about the device. When you click Refresh,
the status is updated immediately.
Figure 36 Status > Library page
You can see, but not modify, the following:
60 Operating the tape library
To Next Page
Loading...
