When a new host group is added, additional host group modes (host mode options) can be
configured. The storage administrator must verify if an additional host group mode is required for
the host group.
CAUTION: Changing host group modes for ports where servers are already installed and
configured is disruptive and requires the server to be rebooted.
Setting the system option modes
The HP service representative sets the system option mode(s) based on the operating system and
software configuration of the host. Notify your HP representative if you install storage agnostic
software (such as backup or cluster software) that might require specific settings.
Configuring the Fibre Channel and FCoE ports
Configure the disk array Fibre Channel and FCoE ports by using XP7 Command View Advanced
Edition Software or the XP7 Remote Web Console (shown). Select the settings for each port based
on your SAN topology. Use switch zoning if you connect different types of hosts to the array through
the same switch.
Installing and configuring the disk array 53
To Next Page
Loading...
Need help?
General
