Installing and configuring the host
This section explains how to install and configure Fibre Channel adapters (FCAs) that connect the
host to the disk array.
Loading the operating system and software
Follow the manufacturer's instructions to load the operating system and software onto the host.
Load all OS patches and configuration utilities supported by HP and the FCA manufacturer.
Installing and configuring the FCAs
Install and configure the FCA driver software and setup utilities according to the manufacturer's
instructions. Configuration settings specific to the XP7 array differ depending on the manufacturer.
Specific configuration information is detailed in the following sections.
WWN
The FCA configuration process might require you to enter the WWN for the array port(s) to which
the FCA connects. Your HP representative can provide you this information or you can display this
information on the SAN switch.
Installing and configuring the host 71
To Next Page
Loading...
