2. Disconnect the power (1) and data (2) cables from the back of the diskette drive.
Figure 5-45 Disconnecting the diskette drive cables
3. Lift the green drive-lock release tab (1) and gently slide the drive out of the chassis at the same
time (2).
Figure 5-46 Removing the diskette drive from chassis
NOTE: To install a diskette drive, reverse the previous steps. You might need to remove the front bezel
to install the drive.
SAS hard drive
This section describes how to remove and install a SAS hard drive.
Removing a SAS hard drive
1. Disconnect power from the system (Predisassembly procedures on page 57), and then remove
the side access panel (
Removing the side access panel on page 61).
ENWW Removing and replacing components 93
To Next Page
Loading...
