2. Gently push the subpanel out the back of the front bezel (1).
Figure 5-12 Removing the bezel blanks
3. Remove the desired bezel blank by applying outward pressure on the subpanel (1) and pulling the
blank away (2).
NOTE: The bezel blanks are keyed to assist you in replacing them. Also, the subpanel can be rotated
90 degrees to install optical drives in a desktop orientation.
Front panel I/O device assembly
This section describes how to remove and install a front panel I/O device assembly.
Removing the front panel I/O device assembly
To remove the front panel I/O device assembly:
1. Disconnect power from the system (
Predisassembly procedures on page 57), remove the side
access panel (
Removing the side access panel on page 61), and then remove the front bezel
(
Removing the front bezel on page 65).
2. If necessary, unlatch the plastic snap that secures the cables inside the chassis (1), and then
disconnect the front panel I/O device assembly cables from the system board (2).
Figure 5-13 Removing front panel I/O device cables
66 Chapter 5 Removal and replacement procedures ENWW
To Next Page
Loading...
