2. Open the PCI card retention clamp. Press the retention clamp levers down to unsnap, and then
rotate them up (1).
Figure 5-28 Removing a PCI Express card
3. If removing a PCI Express x16 graphics card, press in on the release lever (2) while lifting the card
(3) out of the chassis. Store the card in an anti-static bag.
If removing s PCI Express card without a release lever, simply lift the card out of the chassis.
4. Install a PCI slot cover and close the PCI retention clamp. If the PCI retention clamp levers do not
close, ensure that all cards are properly seated, and then try again.
Installing a PCI Express card
To install a PCI Express card:
1. Disconnect power from the system (
Predisassembly procedures on page 57), remove the side
access panel (
Removing the side access panel on page 61), and remove the PCI retainer (PCI
card support bracket on page 76), if installed.
ENWW Removing and replacing components 79
To Next Page
Loading...
