Installing the processor heatsink
To install a heatsink:
1. Disconnect power from the system (
Predisassembly procedures on page 57), remove the side
access panel (
Removing the side access panel on page 61). and then remove the processor
heatsink (
Removing the processor heatsink on page 101).
2. If reusing the original heatsink, apply thermal grease to the center of the processor top surface. If
using a new processor heatsink, do not apply thermal grease to the processor; the a new heat sink
will have grease already applied to the heatsink surface. In this case, discard the thermal grease
protective liner from the bottom of the new heatsink before installing.
3. Carefully seat the processor heatsink onto the system board.
CAUTION: Do not overtighten the heatsink screws. If you overtighten them, you might strip the
threads in the system board tray.
4. Carefully tighten the four screws a little at a time, that is, do not fully tighten one screw and move
onto the next. If you have a torque-limited driver available, tighten the screws to 6 in-lbs.
CAUTION: Ensure that the processor remains level as you tighten the screws.
System processor
This section describes how to remove and install a system processor.
Removing a system processor
1. Disconnect power from the system (Predisassembly procedures on page 57), remove the side
access panel (
Removing the side access panel on page 61), and then remove the processor
heatsink (
Removing the processor heatsink on page 101).
ENWW Removing and replacing components 103
To Next Page
Loading...
