3. Remove the four screws from the back panel (1).
Figure 5-19 Removing the power supply
4. Slide the power supply toward the front of the chassis and lift it out of the chassis (2).
NOTE: To replace the power supply, reverse the previous steps.
System fan assembly
This section describes how to remove the system fan assembly.
Removing the system fan assembly
To remove the system fan assembly:
1. Disconnect power from the system (
Predisassembly procedures on page 57) and remove the side
access panel (
Removing the side access panel on page 61).
ENWW Removing and replacing components 71
To Next Page
Loading...
