NOTE: If you do not press F10 at the appropriate time, you must restart the workstation, and then
press and hold the F10 key again to access the utility.
If you are using a PS 2 keyboard, you might see a keyboard error message—disregard it.
4. When the key icon appears, enter the current password, a slash (/) or alternative delimiter
character, your new password, another slash (/) or alternative delimiter character, and your new
password again as shown:
current password/new password/new password
See
National keyboard delimiter characters on page 45 for information about the alternative
delimiter characters.
NOTE: Type carefully. For security reasons, the characters you enter do not appear on the
screen.
5. Press Enter.
The new password takes effect the next time you power on the workstation.
The power-on and setup passwords can also be changed using the Security options in the Computer
Setup (F10) Utility.
44 Chapter 4 System management ENWW
To Next Page
Loading...
