HP Z210 Series User Manual

Converting to desktop configuration
The Z210 Convertible Mini Tower (CMT) Workstation can be operated in the mini-tower or the desktop
configuration. Follow these steps to convert to desktop configuration operation:
NOTE: See the workstation Maintenance and Service Guide for installation details for the following
steps.
1. Prepare the workstation for component installation (see Preparing the workstation for component
installation on page 34).
2. Remove the front bezel from the workstation.
3. Press gently on the edges of the optical drive bay filler panel, and remove it from the front bezel
as shown in the following figure.
Figure 3-4 Removing the ODD bay filler panel
4. Rotate the filler panel 90 degrees to a horizontal position.
5. Align the slots in the filler panel frame with the tabs in the front bezel. Press the optical drive filler
panel back into the front bezel until it snaps into place as shown in the following figure.
Figure 3-5 Installing the ODD bay filler panel
ENWW
Converting to desktop configuration
17

HP Z210 Series Specifications

General

Brand	HP
Model	Z210 Series
Category	Desktop
Language	English