TYPE-C connector CN5302
Repair the Type-C connector:
1) Use a hot air gun to melt the solder on the pins. Pin solder with soldering iron and absorber.
You can gently push down with the soldering iron once everything is molten to move the M1
out of the through holes.
2) Use a hot air gun to melt the solder on the pins.
3) Lift the CN5302 connector from the circuit board.
4) Place the new component on the circuit board. Be sure that it matches the circuit board
footprint.
5) Solder the new component.
To Next Page
Loading...
