HP Z25xs G3 - Connector Board Connectors Repair; USB 3.0 CN154 Repair (Connector Board); USB Type-C CN152 Repair (Connector Board)

22
For Connector Board
USB 3.0 connector CN154
Repair the Connector board connector:
1) Use a hot air gun to melt the solder on the pins. Pin solder with soldering iron and absorber. You
can gently push down with the soldering iron once everything is molten to move the M1 out of the
through holes.
2) Lift the CN154 connector from the circuit board.
3) Place the new component on the circuit board. Be sure that it matches the circuit board footprint.
4) Solder the new component.
USB TYPE-C connector CN152
Repair the USB TYPE-C connector:
1) Use a hot air gun to melt the solder on the pins. Pin solder with soldering iron and absorber. You
can gently push down with the soldering iron once everything is molten to move the M1 out of the
through holes.
2) Use a hot air gun to melt the solder on the pins.
3) Lift the CN152 connector from the circuit board.
4) Place the new component on the circuit board. Be sure that it matches the circuit board footprint.
5) Solder the new component.