EasyManuals Logo

HP Z440 Workstation Series Service Manual

HP Z440 Workstation Series
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #130 background imageLoading...
Page #130 background image
D Statement of Volatility
Z440 Workstation
HP confirms that Intel-based Z440 personal workstation contains DDR RAM volatile memory (memory
amount depends on the customer configuration). In addition, the motherboard in the condition originally
shipped without subsequent modification or the addition or installation of any applications, features, or
functionality, contain the following nonvolatile memory: PCH Real Time Clock (RTC) battery backed-up
configuration memory (256 Bytes), Super I/O battery backed-up configuration memory (16 Bytes), masked
keyboard ROM (2K Bytes), DIMM Serial Presence Detect (SPD) configuration data (256 Bytes per module, 128
Bytes programmable), TPM module (2.35 kB), and Serial Flash IC for System BIOS (128M Bits).
The volatile memory is cleared by removing power from the system for greater than 30 seconds. The
nonvolatile memory on the motherboard is restored by following the steps below:
1. If TPM Ownership has been taken enter F10 setup.
2. Navigate to the Security tab.
3. Select TPM Embedded Security > TPM Clear > Clear.
4. Save and exit BIOS.
5. Press F1 when prompted to accept the clearing of the TPM nonvolatile memory.
6. Download the latest BIOS for this system and operating system off of the HP website.
7. Follow the instructions on the website to flash the BIOS. This will clear all settings and passwords
related to the BIOS.
8. Power down the system and remove the AC power cord. The RTC and Super I/O battery backed-up
memory is cleared by removing the battery found on the motherboard, allowing the board to sit for
greater than 60 seconds, and then replacing the battery.
The DIMM SPD EEPROM is not readily available to the user, however there appear to be tools publicly
available to read and write this part. To eliminate the possibility that it could contain sensitive information,
remove the DIMMs or use one of these tools.
Z640 Workstation
HP confirms that Intel-based Z640 personal workstation contains DDR RAM volatile memory (memory
amount depends on the customer configuration). In addition, the motherboard in the condition originally
shipped without subsequent modification or the addition or installation of any applications, features, or
functionality, contain the following nonvolatile memory: PCH Real Time Clock (RTC) battery backed-up
configuration memory (256 Bytes), Super I/O battery backed-up configuration memory (16 Bytes), masked
keyboard ROM (2K Bytes), DIMM Serial Presence Detect (SPD) configuration data (256 Bytes per module, 128
Bytes programmable), TPM module (2.35 kB), and Serial Flash IC for System BIOS (128M Bits).
The volatile memory is cleared by removing power from the system for greater than 30 seconds. The
nonvolatile memory on the motherboard is restored by following the steps below:
1. If TPM Ownership has been taken enter F10 setup.
2. Navigate to the Security tab.
3. Select TPM Embedded Security > TPM Clear > Clear.
120 Appendix D Statement of Volatility

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Z440 Workstation Series and is the answer not in the manual?

HP Z440 Workstation Series Specifications

General IconGeneral
ChipsetIntel C612
Memory Slots8 DIMM slots
AudioIntegrated Realtek HD ALC221 Audio
Processor OptionsIntel Xeon E5-1600 v3 series; Intel Xeon E5-2600 v3 series
MemoryUp to 128 GB DDR4-2133 ECC
Graphics OptionsNVIDIA Quadro or AMD FirePro professional graphics cards
Power Supply700W 90% efficient, wide-ranging, active Power Factor Correction (PFC)
Operating SystemWindows 10 Pro, Windows 7 Professional, or Linux
Weight11 kg
NetworkIntegrated Intel I218LM PCIe GbE
Expansion Slots1 PCIe Gen2 x1, 1 PCI

Related product manuals