Power cord set requirements12
The power supplies on some computers have external power switches.
The power cord set received with the computer meets the requirements for use in the country where
you purchased the equipment.
Power cord sets for use in other countries must meet the requirements of the country where you use the
computer.
General requirements
These requirements are applicable to all countries.
1. The power cord must be approved by an acceptable accredited agency responsible for evaluation in
the country where the power cord set will be installed.
2. The power cord set must have a current capacity of 15A minimum for North America, 13A minimum
for Taiwan, 12A minimum for Japan, and 10A minimum for all other countries and a nominal voltage
rating of 125 V AC or 250 V AC, as required by each country’s power system.
3. The diameter of the wire must be a minimum of 14 AWG for North America, a minimum of 1.25 mm
2
for Taiwan and Japan, and a minimum of 1.0 mm
2
for all other countries, and the length of the cord
must be greater than 1.8 m (6.0 ft) and less than 3.0 m (9.8 ft).
The power cord should be routed so that it is not likely to be walked on or pinched by items placed upon
it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the
cord exits from the product.
WARNING! Do not operate this product with a damaged power cord set. If the power cord set is
damaged in any manner, replace it immediately.
Japanese power cord requirements
For use in Japan, use only the power cord received with this product.
IMPORTANT: Do not use the power cord received with this product on any other products.
Country-specific requirements
This information provides additional requirements specific to a country.
Power cord set requirements
123
To Next Page
Loading...
