2. To install a memory module, open both latches of the memory module socket (1), and insert the
memory module into the socket (2). Press the module down into the socket so that the module is
fully inserted and properly seated. Be sure that the latches are in the closed position (3).
NOTE: A memory module can be installed in only one way. Match the notch on the module with the
tab on the memory socket.
The computer automatically recognizes the additional memory when you turn on the computer.
Solid-state drive
To remove the solid-state drive, use these procedures.
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 26).
2. Remove the access panel (see Access panel on page 29).
3. Remove the CPU/memory panel (see CPU/memory panel on page 32).
Remove the solid-state drive:
44
Chapter 4 Removal and replacement procedures
To Next Page
Loading...
