4. Remove the heat sink from the computer (4).
NOTE: The processor is attached to the bottom of the heat sink. When the heat sink is removed,
HP recommends that the heat sink be left resting upside down, with the processor resting on top of
the heat sink. Failure to follow this caution can result in damage to the processor.
To replace the heat sink, reverse the removal procedures.
Processor
To remove the processor, use these procedures.
Before removing the processor, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 26).
2. Remove the access panel (see Access panel on page 29).
3. Remove the CPU/memory panel (see CPU/memory panel on page 32).
4. Remove the drive/memory fan (see Memory fan on page 40).
5. Remove the heat sink (see Heat sink on page 46).
Remove the processor:
1. Position the heat sink upside down.
2. Release the four clips (1) that secure the processor bracket to the heat sink.
3. Remove the processor bracket (2) from the heat sink by lifting it straight up.
4. Carefully release the processor holder clips (3) that secure the processor to the processor bracket.
Processor
47
To Next Page
Loading...
