HP Z8 Fury G5 - Pcie Retainer Fan

2. Swing the right side of the PCIe retainer panel (2) up and away from the computer until it rests at an
angle.
3. Remove the PCIe retainer panel (3).
To install the PCIe retainer panel, reverse the removal procedure.
PCIe retainer fan
To remove the PCIe retainer fan, use these procedures.
Before removing the PCIe retainer fan, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 26).
2. Remove the access panel (see Access panel on page 29).
3. Remove the PCIe retainer panel (see PCIe retainer panel on page 49).
Remove the PCIe retainer fan:
1. Lift the release latch (1).
2. Swing the PCIe retainer fan (2) upward until it rests at an angle.
50
Chapter 4 Removal and replacement procedures