3. Release the right side cover (2) by lifting the rear edge until it rests at an angle.
4. Remove the right side cover (3) by sliding it up and back at an angle.
5. If power supply security screws have been installed, remove the Torx15 power supply security
screws (1).
6. Press and hold the power supply release latches (2) located next to the power connectors.
7. Remove the power supplies (3) from the computer.
To install the power supplies, reverse the removal procedures.
CPU/memory panel
To remove the CPU/memory panel, use these procedures.
Before removing the CPU/memory panel, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 26).
32
Chapter 4 Removal and replacement procedures
To Next Page
Loading...
