(11) CPU1 memory power cable
NOTE: If installed, disconnect the external and external drive connectors. Drive configuration
varies by model.
2. Release the system board (1) by sliding it toward the front of the computer chassis.
3. Swing the top edge of the system board (2) outward until it clears the top edge of the computer
chassis.
4. Remove the system board (3) by sliding it up and forward at an angle.
To install the system board, reverse the removal procedures.
Power distribution board
To remove the power distribution board, use these procedures.
Before removing the power distribution board, follow these steps:
Power distribution board
55
To Next Page
Loading...
